Installation - Chrysler 2005 Crossfire SRT6 Service Manual

ZH

INSTALLATION

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPT-
ING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MIN-
UTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNO-
SIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE
THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
1. Position the headlamp switch into the lower instru-
ment panel (1).
2. Install the headlamp switch attachment screws (1)
and (2), and secure.
3. Install the headlamp switch interior trim panel.
4. Connect the harness connectors at the rear of the
headlamp switch and lock to secure.
5. Install the lower instrument panel. (Refer to 23 -
BODY/INSTRUMENT
PANEL ASSEMBLY - INSTALLATION).
6. Connect the negative battery cable.
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION 8L - 111
PANEL/INSTRUMENT