Chrysler 2005 Crossfire SRT6 Service Manual page 1362

8O - 6 RESTRAINTS - ELECTRICAL DIAGNOSTICS
DRIVER AIRBAG SQUIB CIRCUIT (CONTINUED)
2.
WITH THE DRB III , READ ACTIVE DTCs
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG
FACE DOWN ON A HARD SURFACE; THE AIRBAG WILL PROPEL
INTO THE AIR IF ACCIDENTALLY DEPLOYED, AND COULD
RESULT IN SERIOUS OR FATAL INJURY.
Disconnect the Driver Airbag.
Note: Check connectors - Clean/repair as necessary.
Connect the appropriate Load Tool to the Driver Airbag Squib connec-
tor.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
With the DRB III , read the active Airbag DTCs.
Does the DRB III display an active Driver Airbag Squib DTC?
Yes >> Go to 3
No >> Replace the Driver Airbag. (Refer to 8 - ELECTRICAL/RESTRAINTS/DRIVER AIRBAG - REMOVAL).
Perform AIRBAG VERIFICATION TEST.
3.
WITH THE DRB III , READ ACTIVE DTCs
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Load Tool from the Driver Airbag connector.
Disconnect the Clockspring connector C232 (red 2–wire connector)
located at the base of the steering column.
Note: Check connectors - Clean/repair as necessary.
Connect the appropriate Load Tool to the Clockspring connector.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
With the DRB III , read the active Airbag DTCs.
Does the DRB III display an active Driver Airbag Squib DTC?
Yes >> Go to 4
No >> Replace the Clockspring / Repair the Clockspring jumper harness as necessary. (Refer to 8 - ELEC-
TRICAL/RESTRAINTS/CLOCKSPRING - REMOVAL).
Perform AIRBAG VERIFICATION TEST.
ZH