Chrysler 2005 Crossfire SRT6 Service Manual page 1196

8L - 130 LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS
DOME LAMP CIRCUIT (CONTINUED)
2.
MEASURE THE VOLTAGE OF THE DOME LAMP CIRCUIT
Turn the ignition on.
Measure the voltage of the Dome Lamp circuit between the Dome
Lamp harness connector and Ground.
Is voltage present?
Yes >> Repair the Dome Lamp circuit for a short to battery.
Perform BODY VERIFICATION TEST.
No >> Go to 3
3.
MEASURE THE RESISTANCE OF THE DOME LAMP CIRCUIT
Turn the ignition off.
Measure the resistance of the Dome Lamp circuit between the Dome
Lamp harness connector and ground.
Is the resistance below 10K ohms?
Yes >> Repair the Dome Lamp circuit for a short to ground.
Perform BODY VERIFICATION TEST.
No >> Replace the Body Control Module. (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform BODY VERIFICATION TEST.
ZH