Chrysler 2005 Crossfire SRT6 Service Manual page 1609

ZH
STANDARD PROCEDURE - WASHER NOZZLE AIMING
CAUTION: During the adjustment procedure, be careful not to damage the inside opening of the washer
nozzle jet.
Note: Be sure to check that each washer nozzle is properly secured into the cowl grille before attempting
any adjustments.
This model is equipped with two adjustable heated
washer nozzles. The right and left nozzles are identi-
cal. Both nozzles emit two spray streams onto the
windshield wiper sweep pattern. To aim, perform the
following steps:
1. Using a safety pin (1), adjust each nozzle jet as
required to aim the spray within the wiper sweep
pattern.
2. Each adjustment of the jet should be checked by
actuating the washer system switch from inside the
vehicle.
3. After adjustment, a final check of the spray pattern
should be done by actuating the washer system
switch from inside the vehicle with the engine
idling.
WIPERS/WASHERS - SERVICE INFORMATION 8R - 39