Chrysler 2005 Crossfire SRT6 Service Manual page 1585

ZH
*WIPERS INOPERATIVE (CONTINUED)
2.
MEASURE WIPER SWITCH MUX CIRCUIT VOLTAGE
Turn the ignition off.
Disconnect the Body Control Module (BCM) harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Wiper Switch Mux circuit at the BCM C3
connector cavity 65 with the Wiper Switch in the High position.
Is the voltage approximately 12 volts?
Yes >> Replace the Body Control Module. (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL)
Perform BODY VERIFICATION TEST.
No >> Go to 3
3.
MEASURE WIPER/WASHER FUSED B(+) CIRCUIT VOLTAGE
Note: Inspect Fuse 32 located in the Underhood Accessory Fuse
Block. If the fuse is open, repair the cause of the open fuse
before continuing.
Turn the ignition off.
Disconnect the Multi-Function Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused B(+) circuit at the Multi-Function
Switch harness connector.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Repair the Fused B(+) circuit for an open.
Perform BODY VERIFICATION TEST.
WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS 8R - 15