Chrysler 2005 Crossfire SRT6 Service Manual page 1594

8R - 24 WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS
*WIPERS INTERMITTENT SPEED INOPERATIVE (CONTINUED)
MULTI-FUNCTION SWITCH
BODY CONTROL MODULE
For a complete Wipers/Washers Circuit Diagram, (Refer to 8 - ELECTRICAL/WIPERS/WASHERS - SCHEMATICS
AND DIAGRAMS).
Diagnostic Test
1.
MEASURE WIPER SWITCH MUX CIRCUIT VOLTAGE
Note: If any BCM DTCs are set, diagnose them first before con-
tinuing.
Disconnect the Body Control Module (BCM) connector.
Turn the ignition on.
Measure the BCM C3 harness connector cavity 65 for voltage with the
Wiper Switch in the Intermittent position.
Is the voltage approximately 12 volts?
Yes >> Replace the Body Control Module. (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Replace the Multi-Function Switch. (Refer to 8 - ELECTRI-
CAL/LAMPS/LIGHTING - EXTERIOR/MULTI-FUNCTION SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH