Chrysler 2005 Crossfire SRT6 Service Manual page 1482

8O - 126 RESTRAINTS - SERVICE INFORMATION
1. Verify the negative battery cable (2) is discon-
nected before proceeding. Wait two minutes for
the system capacitor to discharge before fur-
ther service.
2. Position the side impact airbag to the door.
3. Install new mounting rivets (1) for the side impact
airbag.
Note: Use only the proper rivets when reinstalling
the side impact airbag.
4. Connect the squib connector (2).
CAUTION: Use caution when connecting the squib
harness connector to the side impact airbag
receptacle. Improper assembly of these connec-
tors can result in damage to the airbag circuits or
connector insulators.
5. Install the door trim panel. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - INSTALLATION).
6. Install the ignition key.
7. Do not reconnect the negative battery cable at this
time. Perform the Supplemental Restraint System
verification test procedure after servicing any Supplemental Restraint System component. (Refer to 8 - ELEC-
TRICAL/RESTRAINTS - STANDARD PROCEDURE).
ZH