Chrysler 2005 Crossfire SRT6 Service Manual page 1081

ZH
*RIGHT PARK LAMP INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
RIGHT PARK LAMP BULB
For a complete Exterior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR -
SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE RIGHT PARK LAMP BULB
Note: If the right front side marker lamp, the right park lamp, the right rear side marker lamp, and the right
tail lamp are inoperative, inspect Fuse 7 located in the Illumination Control Module/IP Fuse Block. If the fuse
is open, repair the cause of the open fuse before continuing.
Turn the ignition off.
Remove the Right Park Lamp bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Right Park Lamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/
MARKER LAMP - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE FUSED B(+) CIRCUIT RESISTANCE
Disconnect the Right Park Lamp harness connector.
Disconnect the Illumination Control Module harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the Right Park Lamp harness con-
nector and the Illumination Control Module harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open between the
Right Park Lamp and the Illumination Control Module.
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS 8L - 15
POSSIBLE CAUSES