Table of Contents
Advertisement
ZH
REAR WINDOW ANTENNA
DESCRIPTION
The liftgate glass contains the audio antenna (4)
attached to the inside surface. Grid lines running hor-
izontally form the antenna, which terminates to bus
bars (1) at either side. Blade type terminals, also
attached to the inside glass surface at the bus bars,
form the beginning connection point for the radio fre-
quency signal.
STANDARD PROCEDURE - ANTENNA GRID REPAIR
Repair of the rear glass antenna bus bars and terminals can be accomplished using a Mopar Rear Window Defog-
ger Repair Kit (Part Number 4267922) or equivalent.
WARNING: MATERIALS CONTAINED IN THE REPAIR KIT MAY CAUSE SKIN OR EYE IRRITATION. THE KIT
CONTAINS EPOXY RESIN AND AMINE TYPE HARDENER, WHICH ARE HARMFUL IF SWALLOWED. AVOID
CONTACT WITH THE SKIN AND EYES. FOR SKIN CONTACT, WASH THE AFFECTED AREAS WITH SOAP
AND WATER. FOR CONTACT WITH THE EYES, FLUSH WITH PLENTY OF WATER. DO NOT TAKE INTER-
NALLY. IF TAKEN INTERNALLY, INDUCE VOMITING AND CALL A PHYSICIAN IMMEDIATELY. USE WITH ADE-
QUATE VENTILATION. DO NOT USE NEAR FIRE OR FLAME. CONTAINS FLAMMABLE SOLVENTS. KEEP
OUT OF THE REACH OF CHILDREN.
1. Mask the repair area (3) on the inside of the rear
glass so that the conductive epoxy can be applied
neatly. Extend the epoxy application onto the rear
glass antenna (2) or bus bar on each side of the
break (1).
2. Follow the instructions in the repair kit for preparing the damaged area.
3. Remove the package separator clamp and mix the two conductive epoxy components thoroughly within the pack-
aging. Fold the package in half and cut the center corner to dispense the epoxy.
4. For rear glass antenna bus bar repairs, mask the area to be repaired with masking tape or a template.
5. Apply the epoxy through the slit in the masking tape or template. Overlap both ends of the break by at least 0.75
inch (19 mm).
AUDIO - SERVICE INFORMATION 8A - 33
Advertisement
Chapters
Table of Contents
