Chrysler 2005 Crossfire SRT6 Service Manual page 1270

8N - 40 POWER LOCKS - SERVICE INFORMATION
INSTALLATION
1. Align the door latch assembly (6) into the door
through the installation opening.
2. Install the door latch assembly attachment screws
(7). Tighten the screws to 8 N·m. (70 in. lbs.).
3. Install the pneumatic supply line to the lock actua-
tor on the door latch assembly.
4. Install the inside handle release cable (8) and the
driver door harness connector (driver door only).
Note: The guide rail must be realigned using the
premarked position before securing the glass
adjustment.
5. Align the guide rail into the door through the instal-
lation opening and install the attachment bolts (2).
Install the lower cover plug (3).
Note: Inspect the door watershield for damage and
replace if necessary.
6. Install the door watershield (1).
7. Install the door lock cylinder. (Refer to 23 - BODY/
DOOR - FRONT/LOCK CYLINDER - INSTALLA-
TION).
8. Install the door interior trim panel. (Refer to 23 -
BODY/DOOR -
INSTALLATION).
DRIVER DOOR LOCK SWITCH
REMOVAL
WARNING: REFER TO RESTRAINTS BEFORE ATTEMPTING ANY DOOR, SEAT, STEERING WHEEL, STEER-
ING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE
PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PER-
SONAL INJURY. (Refer to 8 - ELECTRICAL/RESTRAINTS - WARNING).
FRONT/TRIM PANEL -
ZH