Chrysler 2005 Crossfire SRT6 Service Manual page 1470

8O - 114 RESTRAINTS - SERVICE INFORMATION
5. Move the seat to the full forward position.
Note: The seat track rear bolts are easily accessed
when the seat back is tilted fully forward.
6. Remove the seat track rear bolts (1).
7. Remove the seat belt bolt (2) holding the seat belt
to the seat.
8. Disconnect the negative battery cable (2). Wait two
minutes for the system capacitor to discharge
before further service.
9. Tilt the seat back, to gain access to the bottom of
the seat.
10. Disconnect the power seat harness connectors.
11. Carefully remove the seat from the vehicle.
12. Remove the carpet retainer button (3) at the pas-
senger compartment rear wall (1).
Note: Do not pry on the carpet retainer button, the
button will unscrew from the fastener.
13. Fold back the carpet near the center of the door
sill to gain access to the side impact sensor.
ZH