Chrysler 2005 Crossfire SRT6 Service Manual page 1078

8L - 12 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*LEFT FRONT TURN LAMP INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
LEFT FRONT TURN LAMP BULB
For a complete Exterior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR -
SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE LEFT FRONT TURN LAMP BULB
Note: If all of the turn signal lamps and both of the back up lamps are inoperative, inspect Fuse 4 located
in the Illumination Control Module/IP Fuse Block. If the fuse is open, repair the cause of the open fuse
before continuing.
Turn the ignition off.
Remove the Left Front Turn Lamp bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Left Front Turn Lamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/
MARKER LAMP - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE FUSED B(+) CIRCUIT RESISTANCE
Disconnect the Left Front Lamp Assembly harness connector.
Disconnect the Multi-Function Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the Left Front Lamp Assembly har-
ness connector and the Multi-Function Switch harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open between the Left
Front Turn Lamp and the Multi-Function Switch.
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH