Chrysler 2005 Crossfire SRT6 Service Manual page 1381

ZH
PASSENGER AIRBAG SQUIB CIRCUIT (CONTINUED)
2.
WITH THE DRB III , READ ACTIVE DTCs
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG
FACE DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL
INTO THE AIR IF ACCIDENTALLY DEPLOYED, AND COULD
RESULT IN SERIOUS OR FATAL INJURY.
Disconnect the Passenger airbag.
Note: Check connectors - Clean/repair as necessary.
Connect the appropriate Load Tool to the Passenger Airbag Squib
connector.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
With the DRB III , read the active Airbag DTCs.
Does the DRB III display an active Passenger Airbag Squib DTC?
Yes >> Go to 3
No >> Replace the Passenger Airbag. (Refer to 8 - ELECTRICAL/RESTRAINTS/PASSENGER AIRBAG -
REMOVAL).
Perform AIRBAG VERIFICATION TEST.
3.
MEASURE THE RESISTANCE OF THE PASSENGER SQUIB LINE 1 CIRCUIT
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the ORC harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect the appropriate harness adapter to the ORC connector.
Disconnect the Load Tool from the Passenger Airbag Squib connector.
Measure the resistance of the Passenger Squib Line 1 circuit from the
ORC adapter to the Passenger Airbag Squib connector.
Is the resistance below 1.0 ohm?
Yes >> Go to 4
No >> Repair the Passenger Squib Line 1 circuit for an open.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 25