Chrysler 2005 Crossfire SRT6 Service Manual page 1550

8Q - 44 VEHICLE THEFT SECURITY - ELECTRICAL DIAGNOSTICS
REMOTE KEYLESS ENTRY RELAY CONTROL CIRCUIT (CONTINUED)
2.
MEASURE THE VOLTAGE OF THE REMOTE KEYLESS ENTRY RELAY CONTROL CIRCUIT
Turn the ignition on.
Measure the voltage of the Remote Keyless Entry Relay Control circuit
at the Remote Keyless Entry Relay harness connector.
Is voltage present?
Yes >> Repair the Remote Keyless Entry Relay Control circuit for
a short to voltage.
Perform SENTRY KEY VERIFICATION TEST.
No >> Go to 3
3.
MEASURE THE RESISTANCE OF THE REMOTE KEYLESS ENTRY RELAY CONTROL CIRCUIT
Turn the ignition off.
Measure the resistance between ground and the Remote Keyless
Entry Relay Control circuit at the Remote Keyless Entry Relay harness
connector.
Is the resistance below 10K ohms?
Yes >> Repair the Remote Keyless Entry Relay Control circuit for
a short to ground.
Perform SENTRY KEY VERIFICATION TEST.
No >> Replace the Remote Keyless Entry Relay.
Perform SENTRY KEY VERIFICATION TEST.
ZH