Chrysler 2005 Crossfire SRT6 Service Manual page 1193

ZH
HAZARD SWITCH CIRCUIT (CONTINUED)
2.
MEASURE THE VOLTAGE OF THE HAZARD SWITCH CIRCUIT
Turn the ignition on.
Measure the voltage of the Hazard Switch circuit between the Console
Switch Group harness connector and Ground.
Is voltage present?
Yes >> Repair the Hazard Switch circuit for a short to battery.
Perform BODY VERIFICATION TEST.
No >> Go to 3
3.
MEASURE THE RESISTANCE OF THE HAZARD SWITCH CIRCUIT
Turn the ignition off.
Measure the resistance of the Hazard Switch circuit between the Con-
sole Switch Group harness connector and ground.
Is the resistance below 10K ohms?
Yes >> Repair the Hazard Switch circuit for a short to ground.
Perform BODY VERIFICATION TEST.
No >> Replace the Body Control Module. (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS 8L - 127