Chrysler 2005 Crossfire SRT6 Service Manual page 1070

8L - 4 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*LEFT FOG LAMP INOPERATIVE (CONTINUED)
3.
MEASURE LEFT FOG LAMP VOLTAGE
Connect the Illumination Control Module harness connector.
Turn the ignition on.
Turn the fog lamps on.
Measure the voltage of the Fused B(+) circuit at the Left Fog Lamp
harness connector cavity 2.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Replace the Illumination Control Module. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
LAMP SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
4.
MEASURE LEFT FOG LAMP GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Turn the fog lamps off.
Measure the resistance between ground and the Left Fog Lamp har-
ness connector cavity 1.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Left Fog Lamp bulb is installed properly
and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Left Fog Lamp ground circuit for an open.
Perform BODY VERIFICATION TEST.
- EXTERIOR/HEAD-
ZH