Chrysler 2005 Crossfire SRT6 Service Manual page 1105

ZH
*LEFT REAR SIDE MARKER LAMP INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
LEFT REAR SIDE MARKER LAMP BULB
For a complete Exterior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR -
SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE LEFT REAR SIDE MARKER LAMP BULB
Note: If the left front side marker lamp, the left park lamp, the left rear side marker lamp, and the left tail
lamp are inoperative, inspect Fuse 10 located in the Illumination Control Module/IP Fuse Block. If the fuse
is open, repair the cause of the open fuse before continuing.
Turn the ignition off.
Remove the Left Rear Side Marker Lamp bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Left Rear Side Marker Lamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTE-
RIOR/MARKER LAMP - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE FUSED B(+) CIRCUIT RESISTANCE
Disconnect the Left Rear Side Marker Lamp harness connector.
Disconnect the Illumination Control Module harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the Left Rear Side Marker Lamp har-
ness connector and the Illumination Control Module harness connec-
tor.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open between the Left
Rear Side Marker Lamp and the Illumination Control Mod-
ule.
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS 8L - 39
POSSIBLE CAUSES