Multi-Function Switch - Chrysler 2005 Crossfire SRT6 Service Manual

ZH WIPERS/WASHERS - SERVICE INFORMATION 8R - 35

MULTI-FUNCTION SWITCH

DESCRIPTION
WARNING: To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental
restraint system before attempting any steering wheel, steering column, airbag, occupant classification sys-
tem, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge
before performing further diagnosis or service. This is the only sure way to disable the supplemental
restraint system. Failure to take the proper precautions could result in accidental airbag deployment.
The Multifunction Switch and control circuitry (3) is
concealed below the steering column shrouds and will
operate when the ignition switch is turned to the ACC
or ON/RUN positions. Fuse 32 in the Underhood
Accessory Fuse Block protect the circuitry of the
Wiper System and the vehicle.
The Wiper System in addition to HI (1) and LO (2)
speeds, has an intermittent delay (3) mode. The wip-
ers will return to the park position when the wiper por-
tion of the switch is rotated to the OFF position. A mist
function can be operated by briefly pressing the end of
the Multifunction Switch lever inward. In addition to
operating the Wiper System, the Multifunction Switch
also operates high beam/flash to pass and turn sig-
nals.
The Multifunction Switch cannot be adjusted, or
repaired. If faulty, worn, or damaged, the entire unit
must be replaced. For complete Multifunction Switch
removal procedures, refer to Multifunction Switch
removal in the Lamps/Lighting Exterior section. (Refer
to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/
MULTI-FUNCTION SWITCH - REMOVAL).