Chrysler 2005 Crossfire SRT6 Service Manual page 1395

ZH
RIGHT SIDE AIRBAG SQUIB CIRCUIT (CONTINUED)
7.
MEASURE THE VOLTAGE OF THE RIGHT SIDE SQUIB LINE 2 CIRCUIT
With the ignition on.
Measure the voltage of the Right Side Squib Line 2 circuit at the Squib
connector.
Is voltage present?
Yes >> Repair the Right Side Squib Line 2 circuit for a short to
voltage.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 8
8.
MEASURE THE RESISTANCE OF THE RIGHT SIDE SQUIB LINE 1 CIRCUIT
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Measure the resistance between ground and the Right Side Squib
Line 1 circuit.
Is the resistance below 10K ohms?
Yes >> Repair the Right Side Squib Line 1 circuit for a short to
ground.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 9
9.
MEASURE THE RESISTANCE OF THE RIGHT SIDE SQUIB LINE 2 CIRCUIT
With the ignition off.
Measure the resistance between ground and the Right Side Squib
Line 2 circuit.
Is the resistance below 10K ohms?
Yes >> Repair the Right Side Squib Line 2 circuit for a short to
ground.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Replace the Occupant Restraint Controller. (Refer to 8 -
ELECTRICAL/RESTRAINTS/OCCUPANT
CONTROLLER - REMOVAL).
WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS DROPPED AT ANY TIME, IT MUST BE
REPLACED.
Perform AIRBAG VERIFICATION TEST.
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 39
RESTRAINT