Chrysler 2005 Crossfire SRT6 Service Manual page 1371

ZH
DRIVER SEAT BELT TENSIONER SQUIB CIRCUIT (CONTINUED)
7.
MEASURE THE VOLTAGE OF THE DRIVER SEAT BELT SQUIB LINE 2 CIRCUIT
With the ignition on.
Measure the voltage of the Driver Seat Belt Squib Line 2 circuit at the
Squib connector.
Is voltage present?
Yes >> Repair the Driver Seat Belt Squib Line 2 circuit for a short
to voltage.
Perform AIRBAG VERIFICATION TEST. (Refer to 8 -
ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TEST-
ING).
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 8
8.
MEASURE THE RESISTANCE OF THE DRIVER SEAT BELT SQUIB LINE 1 CIRCUIT
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Measure the resistance between ground and the Driver Seat Belt
Squib Line 1 circuit.
Is the resistance below 10K ohms?
Yes >> Repair the Driver Seat Belt Squib Line 1 circuit for a short
to ground.
Perform AIRBAG VERIFICATION TEST. (Refer to 8 -
ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TEST-
ING).
Note: When reconnecting Airbag system components, the ignition
must be turned off and the battery must be disconnected.
No >> Go to 9
9.
MEASURE THE RESISTANCE OF THE DRIVER SEAT BELT SQUIB LINE 2 CIRCUIT
With the ignition off.
Measure the resistance between ground and the Driver Seat Belt
Squib Line 2 circuit.
Is the resistance below 10K ohms?
Yes >> Repair the Driver Seat Belt Squib Line 2 circuit for a short
to ground.
Perform AIRBAG VERIFICATION TEST. (Refer to 8 -
ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TEST-
ING).
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Replace the Occupant Restraint Controller. (Refer to 8 -
ELECTRICAL/RESTRAINTS/OCCUPANT RESTRAINT CONTROLLER - REMOVAL).
WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS DROPPED AT ANY TIME, IT MUST BE
REPLACED.
Perform AIRBAG VERIFICATION TEST. (Refer to 8 - ELECTRICAL/RESTRAINTS - DIAGNOSIS AND
TESTING).
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 15