ZH
INSTALLATION
1. Install the power top control module to the hydrau-
lic pump bracket (4).
2. Install the power top control module retaining screw
(1).
3. Connect the power top control module harness
connectors (2) and (3).
4. Install the trunk interior trim panel (1).
5. Install the plastic panel retainers (2).
6. Connect the negative battery cable.
7. Perform the Standard Procedure to complete the
installation and programing of the new power top
control module.(Refer to 8 - ELECTRICAL/ELEC-
TRONIC
CONTROL
CONTROL MODULE - STANDARD PROCEDURE)
ELECTRONIC CONTROL MODULES - SERVICE INFORMATION 8E - 109
MODULES/POWER
TOP