Chrysler 2005 Crossfire SRT6 Service Manual page 739

ZH
*NO RESPONSE FROM POWER TOP CONTROL MODULE (CONTINUED)
3.
FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN
Turn the ignition off.
Disconnect the Power Top Control Module harness connector.
Note: Check connector — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused Ignition Switch Output circuit at the
Power Top Control Module harness connector.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Repair the Fused Ignition Switch Output circuit for an
open.
Perform BODY VERIFICATION TEST.
4.
GROUND CIRCUIT OPEN
Turn the ignition off.
Measure the resistance of the Ground circuit from the Power Top Con-
trol Module harness connector to ground.
Is the resistance below 5.0 ohms?
Yes >> Go to 5
No >> Repair the Ground circuit for an open.
Perform BODY VERIFICATION TEST.
ELECTRONIC CONTROL MODULES - ELECTRICAL DIAGNOSTICS 8E - 37