Chrysler 2005 Crossfire SRT6 Service Manual page 1106

8L - 40 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*LEFT REAR SIDE MARKER LAMP INOPERATIVE (CONTINUED)
3.
MEASURE LEFT REAR SIDE MARKER LAMP VOLTAGE
Connect the Illumination Control Module harness connector.
Turn the ignition on.
Turn the side marker lamps on.
Measure the voltage between the Left Rear Side Marker Lamp har-
ness connector cavity 2 and ground.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Replace the Illumination Control Module. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
LAMP SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
4.
MEASURE LEFT REAR SIDE MARKER LAMP GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Turn the side marker lamps off.
Measure the resistance between the Left Rear Side Marker Lamp har-
ness connector cavity 1 and ground.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Left Rear Side Marker Lamp bulb is
installed properly and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Left Rear Side Marker Lamp ground circuit for
an open.
Perform BODY VERIFICATION TEST.
- EXTERIOR/HEAD-
ZH