Chrysler 2005 Crossfire SRT6 Service Manual page 743

ZH
*NO RESPONSE FROM CONTROLLER ANTILOCK BRAKE (CONTINUED)
3.
FUSED B+ CIRCUIT(S) OPEN
Turn the ignition off.
Disconnect the CAB harness connector.
Note: Check connector — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused B+ circuits at the CAB harness con-
nector.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Repair the Fused B+ circuit(s) for an open.
Perform ABS VERIFICATION TEST.
4.
TRACTION SYSTEM RELAY OUTPUT CIRCUIT OPEN
With the ignition on.
Measure the voltage of the Traction System Relay Output circuit at the
CAB harness connector.
Is the voltage above 10 volts?
Yes >> Go to 5
No >> Repair the Traction System Relay Output circuit for an
open.
Perform ABS VERIFICATION TEST.
ELECTRONIC CONTROL MODULES - ELECTRICAL DIAGNOSTICS 8E - 41