Chrysler 2005 Crossfire SRT6 Service Manual page 1407

ZH
PASSENGER AIRBAG ON/OFF SWITCH SIGNAL CIRCUIT (CONTINUED)
2.
MEASURE THE PASSENGER AIRBAG ON/OFF SWITCH SIGNAL CIRCUIT RESISTANCE
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the ORC harness connector.
Note: Check connector - Clean/repair as necessary.
Measure the resistance of the Passenger Airbag ON/OFF Switch Sig-
nal circuit from the ORC harness connector to the Passenger Seat
Occupant Simulator harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Passenger Airbag On/Off Switch Signal circuit
for an open.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
3.
MEASURE THE PASSENGER AIRBAG ON/OFF SWITCH SIGNAL CIRCUIT RESISTANCE
With the ignition off.
Measure the resistance between ground and the Passenger Airbag
On/Off Switch Signal circuit.
Is the resistance below 10K ohms?
Yes >> Repair the Passenger Airbag On/Off Switch Signal circuit
for a short to ground.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 4
4.
MEASURE THE VOLTAGE OF THE PASSENGER AIRBAG ON/OFF SWITCH SIGNAL CIRCUIT
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
Measure the voltage of the Passenger Airbag On/Off Switch Signal cir-
cuit at the Passenger Seat Occupant Simulator harness connector.
Is voltage present?
Yes >> Repair the Passenger Airbag On/Off Switch Signal circuit
for a short to voltage.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 5
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 51