Removal - Remote Keyless Entry Relay - Chrysler 2005 Crossfire SRT6 Service Manual

ZH
REMOVAL
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the Instrument Cluster. (Refer to 8 -
ELECTRICAL/INSTRUMENT
REMOVAL).
3. Disconnect the 2-pin CAN BUS harness connector
(1) from the SKREEM module.
4. Disconnect the 2-pin harness connector for the
sentry key antenna ring.
5. Disconnect the 18-pin harness connector (1) from
the SKREEM module.
6. Press the retaining tabs apart.
7. Remove the SKREEM module from the base plate.

REMOVAL - REMOTE KEYLESS ENTRY RELAY

1. Remove the underhood accessory fuse block lid
(1).
POWER LOCKS - SERVICE INFORMATION 8N - 47
CLUSTER -