Chrysler 2005 Crossfire SRT6 Service Manual page 764

8E - 62 ELECTRONIC CONTROL MODULES - ELECTRICAL DIAGNOSTICS
*NO RESPONSE FROM SENTRY KEY REMOTE ENTRY MODULE (CONTINUED)
3.
FUSED B+ CIRCUIT OPEN
Turn the ignition off.
Disconnect the SKREEM C1 harness connector.
Note: Check connector — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused B+ circuit at the SKREEM C1 har-
ness connector.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Repair the Fused B+ circuit for an open.
Perform BODY VERIFICATION TEST.
4.
FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN
With the ignition on.
Measure the voltage of the Fused Ignition Switch Output circuit at the
SKREEM C1 harness connector.
Is the voltage above 10 volts?
Yes >> Go to 5
No >> Repair the Fused Ignition Switch Output circuit for an
open.
Perform BODY VERIFICATION TEST.
ZH