Chrysler 2005 Crossfire SRT6 Service Manual page 1124

8L - 58 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*RIGHT TAIL LAMP INOPERATIVE (CONTINUED)
3.
MEASURE RIGHT TAIL/STOP LAMP VOLTAGE
Connect the Illumination Control Module harness connector.
Turn the tail lamps on.
Measure the voltage between the Right Rear Lamp Assembly harness
connector cavity 2 and ground.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Replace the Illumination Control Module.
Perform BODY VERIFICATION TEST.
4.
MEASURE RIGHT TAIL/STOP LAMP GROUND CIRCUIT RESISTANCE
Turn the tail lamps off.
Measure the resistance between the Right Rear Lamp Assembly har-
ness connector and ground.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Right Tail/Stop Lamp bulb is installed
properly and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Right Rear Lamp Assembly ground circuit for
an open.
Perform BODY VERIFICATION TEST.
ZH