Chrysler 2005 Crossfire SRT6 Service Manual page 1415

ZH
PASSENGER SEAT BELT SWITCH CIRCUIT (CONTINUED)
2.
MEASURE THE VOLTAGE OF THE PASSENGER SEAT BELT SWITCH SENSE CIRCUIT
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the ORC connector.
Note: Check connectors - Clean/repair as necessary.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
Measure the voltage of the Passenger Seat Belt Switch Sense circuit
at the Passenger Seat Belt Switch harness connector.
Is voltage present?
Yes >> Repair the Passenger Seat Belt Switch Sense circuit for a
short to voltage.
Perform AIRBAG VERIFICATION TEST.
No >> Go to 3
3.
MEASURE THE RESISTANCE OF THE PASSENGER SEAT BELT SWITCH SENSE CIRCUIT
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
Measure the resistance of the Passenger Seat Belt Switch Sense cir-
cuit between the ORC and the Passenger Seat Belt Switch harness
connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 4
No >> Repair the Passenger Seat Belt Switch Sense circuit for
an open.
Perform AIRBAG VERIFICATION TEST.
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 59