Chrysler 2005 Crossfire SRT6 Service Manual page 921

ZH
1. Install the horn switch into the steering wheel, then
route the driver airbag harness and connector (3)
through the opening in the horn switch.
Note: Be sure the horn switch preload springs are
centered over the mounting studs (2).
2. Press downward evenly on the horn switch and
install the horn switch retaining nuts. Tighten the
nuts to 5 N·m (44 in. lbs.).
3. Connect the horn switch harness connector (1).
4. Install the airbag. (Refer to 8 - ELECTRICAL/RE-
STRAINTS/DRIVER AIRBAG - INSTALLATION).
5. Connect the negative battery cable (2).
HORN - SERVICE INFORMATION 8H - 15