Chrysler 2005 Crossfire SRT6 Service Manual page 1336

8N - 106 POWER SEATS - SERVICE INFORMATION
2. Position the recliner motor to the seat back frame
and install the attachment bolt (1). Tighten the
motor bolt to 4 N·m (35 in. lbs.).
3. Connect the recliner motor harness connector (2).
4. Install the seat back cover. (Refer to 23 - BODY/
SEATS/SEAT BACK COVER - INSTALLATION).
5. Connect the negative battery cable.
POWER SEAT TRACK
REMOVAL
1. Remove the front seat. (Refer to 23 - BODY/
SEATS/SEAT - REMOVAL).
2. Remove the power seat switch assembly. (Refer to
8 - ELECTRICAL/POWER SEATS/DRIVER SEAT
SWITCH - REMOVAL).
3. Remove the power seat track rear inboard and out-
board attachment bolts (1).
4. Tilt the rear track mechanism outward then remove
the power seat track front inboard and outboard
attachment bolts (2).
ZH