Chrysler 2005 Crossfire SRT6 Service Manual page 1120

8L - 54 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*LEFT REAR TURN LAMP INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
LEFT REAR TURN LAMP BULB
For a complete Exterior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR -
SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE LEFT REAR TURN LAMP BULB
Note: If all of the turn signal lamps and both of the back up lamps are inoperative, inspect Fuse 4 located
in the Illumination Control Module/IP Fuse Block. If the fuse is open, repair the cause of the open fuse
before continuing.
Turn the ignition off.
Remove the Left Rear Turn Lamp bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Left Rear Turn Lamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/
TAIL LAMP UNIT - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE FUSED B(+) CIRCUIT RESISTANCE
Disconnect the Left Rear Lamp Assembly harness connector.
Disconnect the Multi-Function Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the Left Rear Lamp Assembly har-
ness connector and the Multi-Function Switch harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open between the Left
Rear Turn Lamp and the Multi-Function Switch.
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH