Chrysler 2005 Crossfire SRT6 Service Manual page 712

8E - 10 ELECTRONIC CONTROL MODULES - ELECTRICAL DIAGNOSTICS
*NO RESPONSE FROM POWERTRAIN CONTROL MODULE (CONTINUED)
3.
FUSED ENGINE CONTROL RELAY OUTPUT CIRCUIT OPEN
With the ignition on.
Measure the voltage of the Fused Engine Control Relay Output circuit
at the PCM C5 harness connector.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Repair the Fused Engine Control Relay Output circuit for
an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
4.
PCM GROUND CIRCUITS OPEN
Turn the ignition off.
Measure the resistance of the Ground circuits from the PCM C5 har-
ness connector to ground.
Is the resistance below 5.0 ohms on each ground circuit?
Yes >> Go to 5
No >> Repair the Ground circuit(s) for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ZH