Chrysler 2005 Crossfire SRT6 Service Manual page 1390

8O - 34 RESTRAINTS - ELECTRICAL DIAGNOSTICS
LEFT SIDE AIRBAG SQUIB CIRCUIT (CONTINUED)
10.
WITH THE DRB III , READ DTCs
Note: Ensure the battery is fully charged.
With the DRB III , record and erase all Restraint System DTCs.
All active codes must be resolved before diagnosing any stored codes.
Maintain a safe distance from all airbags while performing the following steps.
With the DRB III , monitor active codes as you work through the system.
Note: Read the DTCs with the Passenger Airbag On/Off Switch in both switch positions.
Wiggle the wiring harness and connectors of the appropriate airbag system and rotate the steering wheel from stop
to stop.
Note: Check connectors - Clean/repair as necessary.
You have just attempted to simulate the condition that initially set the trouble code message.
The following additional checks may assist you in identifying a possible intermittent problem:
• Visually inspect related wire harness connectors. Look for broken, bent, pushed out, spread, corroded or con-
taminated terminals.
• Visually inspect the related harnesses. Look for chafed, pierced, pinched or partially broken wire.
• Refer to any Wiring Diagrams that may apply.
Did the DTC become ACTIVE?
Yes >> Go to 2
No >> The condition that caused this DTC to set is currently not present.
Perform AIRBAG VERIFICATION TEST.
ZH