Chrysler 2005 Crossfire SRT6 Service Manual page 718

8E - 16 ELECTRONIC CONTROL MODULES - ELECTRICAL DIAGNOSTICS
*NO RESPONSE FROM OCCUPANT RESTRAINT CONTROLLER (CONTINUED)
3.
ORC GROUND CIRCUIT OPEN
Turn the ignition off.
Measure the resistance of the Ground circuit from the ORC harness
connector to ground.
Is the resistance below 5.0 ohms?
Yes >> Go to 4
No >> Repair the Ground circuit for an open.
WARNING: WHEN RECONNECTING AIRBAG SYSTEM COMPO-
NENTS, THE IGNITION MUST BE TURNED OFF AND THE BAT-
TERY MUST BE DISCONNECTED FOR TWO MINUTES.
Perform AIRBAG VERIFICATION TEST.
4.
SCI TRANSMIT CIRCUIT OPEN
With the ignition off.
Measure the resistance of the SCI Transmit circuit from the ORC har-
ness connector to the DLC.
Is the resistance below 5.0 ohms?
Yes >> Go to 5
No >> Repair the SCI Transmit circuit for an open.
WARNING: WHEN RECONNECTING AIRBAG SYSTEM COMPO-
NENTS, THE IGNITION MUST BE TURNED OFF AND THE BAT-
TERY MUST BE DISCONNECTED FOR TWO MINUTES.
Perform AIRBAG VERIFICATION TEST.
5.
SCI TRANSMIT CIRCUIT SHORTED TO GROUND
With the ignition off.
Measure the resistance between ground and the SCI Transmit circuit.
Is the resistance above 100 kohms?
Yes >> Go to 6
No >> Repair the SCI Transmit circuit for a short to ground.
WARNING: WHEN RECONNECTING AIRBAG SYSTEM COMPO-
NENTS, THE IGNITION MUST BE TURNED OFF AND THE BAT-
TERY MUST BE DISCONNECTED FOR TWO MINUTES.
Perform AIRBAG VERIFICATION TEST.
ZH