Chrysler 2005 Crossfire SRT6 Service Manual page 1412

8O - 56 RESTRAINTS - ELECTRICAL DIAGNOSTICS
DRIVER SEAT BELT SWITCH CIRCUIT (CONTINUED)
4.
MEASURE THE RESISTANCE OF THE DRIVER SEAT BELT SWITCH GROUND CIRCUIT
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
Measure the resistance of the ground circuit at the Driver Seat Belt
Switch harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Occupant Restraint Controller. (Refer to 8 -
ELECTRICAL/RESTRAINTS/OCCUPANT
CONTROLLER - REMOVAL).
WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS
DROPPED AT ANY TIME, IT MUST BE REPLACED.
Perform AIRBAG VERIFICATION TEST.
No >> Repair the Driver Seat Belt Switch ground circuit for an
open.
Perform AIRBAG VERIFICATION TEST.
RESTRAINT
ZH