Chrysler 2005 Crossfire SRT6 Service Manual page 1283

ZH
*LEFT POWER MIRROR INOPERATIVE (CONTINUED)
OPEN LEFT POWER MIRROR HORIZONTAL MOTOR CIRCUIT
OPEN LEFT POWER MIRROR VERTICAL MOTOR CIRCUIT
LEFT POWER MIRROR
POWER MIRROR SWITCH
For a complete Power Mirrors Circuit Diagram, (Refer to 8 - ELECTRICAL/POWER MIRRORS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
TEST THE LEFT POWER MIRROR HORIZONTAL MOTOR
Turn the ignition off.
Disconnect the Power Mirror Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 3 and ground of the Power Mir-
ror Switch harness connector.
Turn the ignition on.
Connect a jumper wire between cavity 6 and cavity 7 of the Power
Mirror Switch harness connector.
With the jumper wires connected, does the Left Power Mirror
Horizontal Motor Run?
Yes >> Go To 2
No >> Go To 3
2.
TEST THE LEFT POWER MIRROR VERTICAL MOTOR
With the ignition on.
With the jumper wire between cavity 3 and ground of the Power Mirror
Switch harness connector still connected.
Disconnect jumper wire from cavity 7 and connect it to cavity 5 of the
Power Mirror Switch harness connector.
With the jumper wires connected, does the Left Power Mirror
Vertical Motor Run?
Yes >> Replace the Power Mirror Switch. (Refer to 8 - ELECTRI-
CAL/POWER MIRRORS/POWER MIRROR SWITCH -
REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go To 4
POWER MIRRORS - ELECTRICAL DIAGNOSTICS 8N - 53
POSSIBLE CAUSES