Chrysler 2005 Crossfire SRT6 Service Manual page 1522

8Q - 16 VEHICLE THEFT SECURITY - ELECTRICAL DIAGNOSTICS
CAN B BUS (+) CIRCUIT FAILURE (CONTINUED)
2.
MEASURE THE VOLTAGE OF THE CAN B BUS (+) CIRCUIT
Turn the ignition on.
Measure the voltage of the CAN B Bus (+) circuit at the CLP/SSM har-
ness connector.
Is voltage present?
Yes >> Repair the CAN B Bus (+) circuit for a short to voltage.
Perform VTSS VERIFICATION TEST.
No >> Go to 3
3.
MEASURE THE RESISTANCE OF THE CAN B BUS (+) CIRCUIT
Turn the ignition off.
Measure the resistance between ground and the CAN B Bus (+) circuit
at the CLP/SSM harness connector.
Is the resistance below 10K ohms?
Yes >> Repair the CAN B Bus (+) circuit for a short to ground.
Perform VTSS VERIFICATION TEST.
No >> Replace the Central Locking Pump/Security System Mod-
ule. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECU-
RITY/SENTRY
REMOVAL).
Perform VTSS VERIFICATION TEST.
KEY REMOTE ENTRY MODULE -
ZH