Chrysler 2005 Crossfire SRT6 Service Manual page 1199

ZH
*CARGO LAMP INOPERATIVE (CONTINUED)
3.
MEASURE CARGO LAMP GROUND CIRCUIT RESISTANCE
Disconnect the Dome Lamp harness connector.
Note: Check connector - Clean/repair as necessary.
Measure the resistance from the Cargo Lamp harness connector cav-
ity 1 to the Dome Lamp harness connector cavity 1.
Is the resistance below 5.0 ohms?
Yes >> Replace the Dome Lamp. (Refer to 8 - ELECTRICAL/
LAMPS/LIGHTING - INTERIOR/COURTESY LAMP -
REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the open circuit between the Cargo Lamp and the
Dome Lamp.
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS 8L - 133