Chrysler 2005 Crossfire SRT6 Service Manual page 789

ZH
Note: It is not necessary to remove the electrical
connectors to rotate the base plate in the passen-
ger footwell.
4. Remove the three plastic retaining nuts (1) from
the floor panel studs.
5. Lift the base plate and rotate the top of the base
plate toward the rear of the vehicle to expose the
TCM.
6. Remove the two retaining screws (2) from the base
plate, and disconnect the TCM harness connectors.
7. Remove the TCM (1) from the base plate.
ELECTRONIC CONTROL MODULES - SERVICE INFORMATION 8E - 87