8R - 36
WIPERS/WASHERS - SERVICE INFORMATION
WASHER FLUID LEVEL SWITCH
REMOVAL
1. Remove the washer reservoir. (Refer to 8 - ELEC-
TRICAL/WIPERS/WASHERS/WASHER
VOIR - REMOVAL)
2. Gently pry outward on the body of the washer fluid
level switch (2) and pull it away from the rubber
grommet (3).
3. Remove the washer fluid level switch (2) from the
washer reservoir (1).
INSTALLATION
1. Insert the washer fluid level switch (2) into the rub-
ber grommet (3) at the rear of the washer reservoir
(1).
2. Press the washer fluid level switch inward until fully
seated.
3. Install the washer reservoir. (Refer to 8 - ELECTRI-
CAL/WIPERS/WASHERS/WASHER RESERVOIR -
INSTALLATION).
RESER-
ZH