Chrysler 2005 Crossfire SRT6 Service Manual page 1601

Table of Contents

Advertisement

ZH
WIPERS/WASHERS - SERVICE INFORMATION
DESCRIPTION
An electrically operated Intermittent Windshield Wiper and Washer System is standard safety equipment. The Wind-
shield Wiper and Washer Systems include the following major components, which are described in further detail
within this service information:
• Body Control Module - The Body Control Module (BCM) (6) is located in the engine compartment on the
passenger side inside the control module box.
• Heated Washer Nozzle Thermoswitch - The thermoswitch is mounted to the under side of the cowl grille.
• Multi-Function Switch - The multi-function switch (2) is secured to the left side and near the top of the steer-
ing column, just below the steering wheel. Only the control stalk for the multifunction switch is visible; the
remainder of the switch and control circuitry is concealed below the steering column shrouds.
• Washer Fluid Level Switch - The washer fluid level switch (6) is located in the washer fluid reservoir, behind
the right front inner fender liner.
• Washer Nozzles - Two heated washer nozzles (4) are secured into dedicated openings within the cowl grille
at the base of the windshield.
• Washer Plumbing - The plumbing for the washer system consists of rubber hoses and molded plastic fittings.
The plumbing is routed from behind the right front inner fender liner, through the right side of the plenum, up
along the underside of the cowl grille to the washer nozzles.
• Washer Pump/Motor - The washer pump/motor unit (5) is located on the lower and forward side of the
washer reservoir, behind the right front inner fender liner.
• Washer Reservoir - The washer reservoir (5) is concealed behind the right front inner fender liner. The
washer reservoir filler neck is the only visible portion of the reservoir, and it is accessed from the right side of
the engine compartment just forward of the battery.
• Wiper Arm - Two wiper arms (1) are secured with attachment nuts to tapered and threaded studs on the ends
of wiper pivot shafts, near the base of the windshield.
WIPERS/WASHERS - SERVICE INFORMATION 8R - 31

Advertisement

Table of Contents
loading

Table of Contents