Chrysler 2005 Crossfire SRT6 Service Manual page 1312

8N - 82 POWER SEATS - ELECTRICAL DIAGNOSTICS
*DRIVER POWER SEAT RECLINER MOTOR INOPERATIVE (CONTINUED)
DRIVER POWER SEAT RECLINER MOTOR
DRIVER POWER SEAT RECLINER MOTOR CIRCUIT
DRIVER POWER SEAT SWITCH
For a complete Power Seats Circuit Diagram, (Refer to 8 - ELECTRICAL/POWER SEATS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
TEST THE DRIVER POWER SEAT RECLINER MOTOR
Turn the ignition off.
Disconnect the Driver Power Seat Recliner Motor harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire from B(+) to one cavity of the Driver Power
Seat Recliner Motor connector (motor side).
Connect a second jumper wire from ground to the other cavity of the
Driver Power Seat Recliner Motor connector (motor side).
Note recliner movement, if no recliner movement is noted, reverse the
jumper wires at the Recliner Motor connector.
Did the Driver Power Seat Recliner move backward or forward?
Yes >> Replace the Driver Power Seat Switch.
Perform BODY VERIFICATION TEST.
No >> Replace the Driver Power Seat Recliner Motor. (Refer to 8 - ELECTRICAL/POWER SEATS/RECLINER
MOTOR - REMOVAL).
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH