Central Locking Pump/Security - Chrysler 2005 Crossfire SRT6 Service Manual

ZH
CENTRAL LOCKING PUMP/SECURITY SYSTEM MODULE SYSTEM UNDERVOLTAGE (CONTINUED)
When Monitored and Set Condition
• When Monitored: Ignition on. The Central Locking Pump/Security System Module (CLP/SSM) monitors the
Fused B(+) circuit voltage for proper system voltage.
• Set Condition: If the voltage is below 11 volts, the Diagnostic Trouble Code (DTC) is set.
BATTERY VOLTAGE LOW
FUSED B(+) CIRCUIT HIGH RESISTANCE
CENTRAL LOCKING PUMP/SECURITY SYSTEM MODULE
For a complete Vehicle Theft Security System Circuit Diagram, (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECU-
RITY - SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
WITH THE DRB III , READ DTCs
Turn the ignition on.
With the DRB III , erase DTCs.
Turn the ignition off.
Turn the ignition on.
Start the engine.
With the DRB III , read DTCs.
Does the DRB III display a System Undervoltage DTC?
Yes >> Go to 2
No >> The condition that caused this DTC to set is currently not
present. Inspect the related wiring harness for a possible
intermittent condition.
2.
MEASURE THE BATTERY VOLTAGE
Measure the battery voltage with the engine running.
Is the battery voltage below 10 volts?
Yes >> Refer to the appropriate service information for charging
system testing and repair.
Perform VTSS VERIFICATION TEST.
No >> Go to 3
VEHICLE THEFT SECURITY - ELECTRICAL DIAGNOSTICS 8Q - 3
POSSIBLE CAUSES