Chrysler 2005 Crossfire SRT6 Service Manual page 1382

8O - 26 RESTRAINTS - ELECTRICAL DIAGNOSTICS
PASSENGER AIRBAG SQUIB CIRCUIT (CONTINUED)
4.
MEASURE THE RESISTANCE OF THE PASSENGER SQUIB LINE 2 CIRCUIT
With the ignitin off.
Measure the resistance of the Passenger Squib Line 2 circuit from the
ORC adapter to the Passenger Airbag Squib connector.
Is the resistance below 1.0 ohm?
Yes >> Go to 5
No >> Repair the Passenger Squib Line 2 circuit for an open.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
5.
MEASURE THE RESISTANCE OF THE PASSENGER SQUIB CIRCUITS
With the ignitin off.
Measure the resistance between the Passenger Squib Line 1 circuit
and the Passenger Squib Line 2 circuit at the Passenger Airbag Squib
connector.
Is the resistance below 10K ohms?
Yes >> Repair the Passenger Squib circuits for a short to each
other.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 6
6.
MEASURE THE VOLTAGE OF THE PASSENGER SQUIB LINE 1 CIRCUIT
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
Measure the voltage of the Passenger Squib Line 1 circuit at the
Squib connector.
Is voltage present?
Yes >> Repair the Passenger Squib Line 1 circuit for a short to
voltage.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 7
ZH