Chrysler 2005 Crossfire SRT6 Service Manual page 1141

ZH
*LICENSE LAMP NO.2 INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
LICENSE LAMP BULB
For a complete Exterior Lamps Circuit Diagram,(Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR -
SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE LICENSE LAMP BULB
Note: If both license lamps are inoperative, inspect Fuse 11 located in the Illumination Control Module/IP
Fuse Block. If the fuse is open, repair the cause of the open fuse before continuing.
Turn the ignition off.
Remove the License Lamp bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the License Lamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/LICENSE
PLATE LAMP - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE FUSED B(+) CIRCUIT RESISTANCE
Disconnect the License Lamp No.2 harness connector.
Disconnect the Illumination Control Module harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the License Lamp No.2 harness con-
nector and the Illumination Control Module harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open between the
License Lamp No.2 and the Illumination Control Module.
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS 8L - 75
POSSIBLE CAUSES