Chrysler 2005 Crossfire SRT6 Service Manual page 1368

8O - 12 RESTRAINTS - ELECTRICAL DIAGNOSTICS
DRIVER SEAT BELT TENSIONER SQUIB CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: Ignition on. The Occupant Restraint Controller (ORC) monitors the resistance of the Driver
Seat Belt Squib circuits.
• Set Condition: The Occupant Restraint Controller (ORC) has detected abnormally high voltage, low resistance,
high resistance or an open circuit on one or both of the Driver Seat Belt Squib circuits.
DRIVER SEAT BELT SQUIB CIRCUIT(S) OPEN
DRIVER SEAT BELT SQUIB CIRCUIT(S) SHORT TO VOLTAGE
DRIVER SEAT BELT SQUIB CIRCUIT(S) SHORT TO GROUND
DRIVER SEAT BELT SQUIB CIRCUITS SHORT TO EACH OTHER
DRIVER SEAT BELT TENSIONER SQUIB
OCCUPANT RESTRAINT CONTROLLER
For a complete Restraints System Circuit Diagram, (Refer to 8 - ELECTRICAL/RESTRAINTS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
WITH THE DRB III , READ DTCs
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
Note: Ensure the battery is fully charged.
Turn the ignition on.
With the DRB III , select ACTIVE or STORED DTCs.
Is the DTC ACTIVE?
Yes >> Go to 2
No >> Go to 10
POSSIBLE CAUSES
ZH