Chrysler 2005 Crossfire SRT6 Service Manual page 1591

ZH
*WIPERS LOW SPEED INOPERATIVE (CONTINUED)
MULTI-FUNCTION SWITCH
BODY CONTROL MODULE
WIPER MOTOR
For a complete Wipers/Washers Circuit Diagram, (Refer to 8 - ELECTRICAL/WIPERS/WASHERS - SCHEMATICS
AND DIAGRAMS).
Diagnostic Test
1.
TEST THE WIPER MOTOR
Note: If any BCM DTCs are set, diagnose them first before con-
tinuing.
Turn the ignition off.
Disconnect the Body Control Module (BCM) C2 harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 2 of the BCM C2 harness con-
nector and B(+).
Connect a jumper wire between cavity 41 of the BCM C2 harness con-
nector and ground.
With the jumper wires connected, does the Wiper Motor move?
Yes >> Go to 2
No >> Replace the Wiper Motor. (Refer to 8 - ELECTRICAL/WIP-
ERS/WASHERS/FRONT WIPER MOTOR - REMOVAL).
Perform BODY VERIFICATION TEST.
WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS 8R - 21
POSSIBLE CAUSES