Chrysler 2005 Crossfire SRT6 Service Manual page 1388

8O - 32 RESTRAINTS - ELECTRICAL DIAGNOSTICS
LEFT SIDE AIRBAG SQUIB CIRCUIT (CONTINUED)
4.
MEASURE THE RESISTANCE OF THE LEFT SIDE SQUIB LINE 2 CIRCUIT
With the ignition off.
Measure the resistance of the Left Side Squib Line 2 circuit from the
ORC adapter to the Left Side Airbag Squib connector.
Is the resistance below 1.0 ohm?
Yes >> Go to 5
No >> Repair the Left Side Squib Line 2 circuit for an open.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
5.
MEASURE THE RESISTANCE OF THE LEFT SIDE SQUIB CIRCUITS
With the ignition off.
Measure the resistance between the Left Side Squib Line 1 circuit and
the Left Side Squib Line 2 circuit at the Left Side Airbag Squib con-
nector.
Is the resistance below 10K ohms?
Yes >> Repair the Left Side Squib circuits for a short to each
other.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 6
6.
MEASURE THE VOLTAGE OF THE LEFT SIDE SQUIB LINE 1 CIRCUIT
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
Measure the voltage of the Left Side Squib Line 1 circuit at the Squib
connector.
Is voltage present?
Yes >> Repair the Left Side Squib Line 1 circuit for a short to volt-
age.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 7
ZH