Mazda 2002 6 Workshop Manual page 1186

BLOWER MOTOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
1 Blower motor connector
2 Blower motor
3. Install in the reverse order of removal.
End Of Sie
BLOWER MOTOR INSPECTION
1. Connect battery positive voltage to terminal A and ground to terminal B of the blower motor and verify its
operation.
• If not as specified, replace the blower motor.
End Of Sie
RESISTOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the car navigation unit. (See
4. Remove in the order indicated in the table.
1 Resistor connector
2 Resistor
5. Install in the reverse order of removal.
End Of Sie
CONTROL SYSTEM
T–98 CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)
A6E854061140W01
A6E8540W060
A6E854061140W02
U
A6E8540W010
A6E854061215W01
A6E8540W011
U–35